Reciprocating Engine Induction & Cooling Systems

47 flashcardspar Coldtour
Réviser ces flashcardsGratuit · répétition espacée · iPhone, Android, Mac et web

Toutes les cartes

1
What does a fuel-injected engine have that prevents the loss of induction air if the air inlet filter should become covered with ice?
An alternate air valve allows warm air frmoinside the engine cowling to flow into the fuel metering system.
2
What would be the effect on engine operation of an air leak in the intake pipe for one cylinder?
The cylinder would run lean. Detonation could (will) occur.
3
What must be inspected on the cooling system of an air-cooled engine?
All of the baffles and airseals must be in place and in good condition.
4
Why should an air-cooled engine not be run-up to high power without the cowling installed?
The engine depends on the cowling to force sir through the cylinder fins to remove the excess heat.
5
Why do some air-cooled engine installations have cowl flaps?
Cowl flaps produce an area of low pressure on one side of the engine to pull air through the colling fins on the cylinders.
6
What documents describe the proper use of cowl flaps on an air-cooled engine?
The Pilot's Operating Handbook.
7
Why does ice in the throat of a float caburetor
When liquid fuel evaporates it absorbs engough heat from the air to cause the moisture to condense out and freeze.
8
Are internally driven superchargers located before or after the carburetor?
Internally driven superchargers compress the air/fuel mixture after it leaves the carburetor, while externally driven superchargers (turbochargers) xompress the ai air before it is mixed with the metered fuel from the carburetor.
9
What are the THREE main parts of a tyoical turbosupercharger
-The Compressor assembly
-The Turbine Wheel assembly
-Full Floating Shaft Bearing assembly
10
How is a tubrosupercharger (turbocharger) driven?
Externally driven superchargers derive their power from the energy of engien exhaust gases directed agaisnt a turbine that drives an impeller that compresses the incoming air.
11
How is a supercharger driven?
The supercharger is directly driven from the engine and is internal to the engine.
12
How does an aubentor system increase cooling airflow over a reciprocating engine?
Augmentors use exhaust gas velocity to cause airflow over the engine. In this way, such that the engine is not entirely dependent on the prop wash.
13
Why is it very important that the induction air filters be kept clean and repalced as oftern as the manufacturer recommends?
Clogger air filters can restrict the air entering the engine.
14
Does the application of carbretor heat cause the fuel-air mixture to become richer or leaner?
The less dense, heated air draws the same amount of fuel from the carburetor as cold air; therefore the mixture becomes richer.
15
What happens to engine RPM when carburetor heat is applied?
The RPM drops.
16
Why should the use of carburetor heat be limited when operating an engine with the aircraft on the ground?
The air that flows into the engine when carburetor heat is applied is not filtered.
17
Why is a fuel-injected reciprocating engine not as prone to icing as an engine equipped with a float carburetor?
In a fuel injected engine, the liquid fuel evaporates in the intake chamber of the hot cylinder head. In a carbureted engine, as air flows through the carburetor venturi, the pressure drops, decreaseing temperature and increasing chances of icing.
18
What creates the pressure of the air in a pressure cowling?
The forward velocity of the airplane as air enters openings in the cowling and flows into the engine compartment.
19
What is meant by pressure cooling of an air-cooled engine?
Ram air on one side of the engine is forced by a series of baffles to flow through the fins on the cylinderto a low-pressure area on the other side of the engine.
20
What controls the amount of air cooling in a pressure cowling system?
The exit air is controlled through the use of cowl flaps. The cowl flaps are closed to reduce the amount of airflow over the engine.
21
What is the purpouse of engine baffles and seals in a pressure cowling system?
The baffles and seals cause the air to be directed over the cooling fins on the cylinders.
22
Where can you find what is the maximum amount of cylinder fin area that can be removed in order to clean out a damaged area?
In the engine overhaul manual.
23
How is heat removed from the liquid in a liquid-cooled engine?
By flowing air over a radiator.
24
Why is it important to folow proper maintenance procedures on a turbocharger?
Turbochargers rotate at high speeds and generate significant amounts of heat. Proper oil flow and control through a turbocharger is critical for cooling and control of the turbocharger system. Improper maintenance leads to improper operation and early failure of the system.
25
What are some of the risks associated with ground operation of aircraft engines?
The cooling og the aircraft engine is optimized for inflight conditions. Ground operations do not provide sufficient air to provide the same amount of cooling, and engines can overheat. Follow maintenance manual procedures for ground operations and monitor engine temeratures to prevent the engine from overheating.
26
What are the risksof maintenance-related FOD, and how can it be prevented?
Maintenance related FOD can come in manu different forms. Tools that are laid down on top of an engine or in the inlet duct of a turbine engine can quickly enter the engine and cause major damage to the engine. Other sources of FOC include hardware, safety wire, protective caps, and items falling out of aviation mechanic's pockets, all of which can cause damage to an engine.
27
What cautions are to be taken when servicing a liquid cooled engine?
The chemicals used in coolants can be harmful if ingested and can cause irritation to exposed skin. Use proper PPE when working on the engine. Clean up spilled coolant immediately.
28
Where does the heat taken from that is used to heat the induction air in a reciprocating engine?
From a muff that is installed around some part of the exhaust system.
29
Where does the alternate air come from that is used with a pressure carburetor or fuel-injection system?
From inside the engine cowling.
30
Where does carburetor ice normally form in a carburetor?
In the throat of the carburetor, on and around the throttle valve.
31
What controls the speed of a turbocharger compressor?
The amount of exhaust gas that is forced to flow through the turbine. This is controlled by the position of the waste gate.
32
What is the danger of operating an aircraft reciprocating engine with too high a carburetor air temperature?
Too high a carburetor air inlet temperature can cause the air-fuel mixture to reach its critical temperature and detonate.
33
What is usually installed in a large reciprocating engine between the tubosupercharger and the carburetor?
An intercooler. This is an air-to-air heat exchanger.
34
In what position should the carburetor heat control be placed when starting a reciprocating engine?
It should be in the COLD position.
35
How does an engine air inlet vortex destroyer help prevent foreign object damage to the engien?
A high-velocity stream of compressor bleed air is blown out in front of the engine to break up the vorticies that form in front of the engine when it is operating at high power.
36
What is the purpose of an augmentor tube in the cooling system of an aircraft reciprocating engine?
The augmentor tube uses the velocity of the exhaust gases to produce a low pressure on one side of the engine that helps pull cooling air through it.
37
Where is the highest temperature located in a turbine engine?
At the inlet to the high pressure turbine.
38
How are the turbine inlet guide vanes and first stage turbine blades in some turbine engiens cooled?
High pressure compressed bleed air flows through the hollow guide vanes and hollow turbine blades.
39
Which side of an air-cooled engine cylinder has the greatest amount of cooling fins?
The side of the cylinder which the exhaust valve is located.
40
What should be doen to repair a bent cooling fin in a cast aluminum head?
It is normally beast to leave a bent cast fin alone if it does not restrict the flow of air. Cast fins are brittle and could break off.
41
What is used in a helicopter to increase the amount of cooling air that flows over the engine cylinders?
A belt-driven fan.
42
What should be the position of the cowl flap on a reciprocating engine when it is run on the ground?
They should be wide open when operating the engine on the ground.
43
What is the function of the majority of the air that passes through a turbine engine?
Most of the air is used for cooling.
44
How does metallic sodium in an exhaust valve aid in transferring heat?
The sodium melts when the engine is running, and it sloshes up and down as the valve operates. The sodium picks up heat from the valve head and carries it into the stem so it can be transferred to the cylinder head and dissipated into the air.
45
How is the structure around a turbine engine protected from excessive heat from the engine?
An insulating blanket protects the structure from excessive heat.
46
What is the function of blast tubes that are installed in a pressure cooling system of a reciprocating engine?
These blast tubes direct cooling air to the magnetos and the generator.
47
Of what material is the insullation blanket made that is used to protect the aircraft structure from the heat produced by a turbine engine?
FIberglass sandwiched between sheets of metal foil.
Réviser les 47 cartes gratuitement

Plus de flashcards

Brunei20 cartesHistoire et lettres · Anglaisry(7) Time and frequency words16 cartesLangues · Allemand → Anglaispmugridgeêtre12 cartesFrançaisCosmoAviation Weather Products (Outlook, SAW, TCF, NHC)8 cartesAnglaisBrieSurvey of the Old Testament (Honors)312 cartesHistoire et lettres · AnglaisEmmaPsychology Week 1100 cartesPsychologie et société · AnglaisMelodyspan314 prueba 3 vocab73 cartesLangues · Anglais → Espagnolh0p3mar13psycho dev TD 56 cartesFrançaisganethema 347 cartesLangues · Finnois → AllemandVekeHISTORY OF CHEMISTRY37 cartesSciences · Anglaischarm 3.6 human impact on enviro30 cartesSciences · AnglaismischaWrist and Hand25 cartesMédecine et santé · AnglaisEsha

Révise ces decks dans l’app

Gratuit sur iPhone, Android, Mac et le web. Ajoute n’importe quel deck à ton compte en un tap.

Télécharger dans l’App StoreDisponible sur Google Play
Réviser les 47 cartes gratuitement