ABM IQT Block 2

What are the major components of the E-3 ESMS

What is the frequency range of ESMS

What is the purpose of the IF Processor

How many frequency synthesizers does the ESMS have

How many direction finding channels does each antenna have

Who initially brings up the system and clears members to turn on workstations and log into Windows

What is the definition of Electronic Warefare

What are the three basic divisions of Electronic Warfare

What division of EW involving actions tasked by, or under direct control of an operational commander to search for, intercept and locate sources of intentional and unintentional radiated EM energy for the purposes of immediate threat recognition ____________

Actions taken to prevent or reduce the enemy's effective use of the EM spectrum, primarily through jamming and deception is ____________

Actions taken to attempt to retain use of its EM equipment, despite the attacking force's use of EW the definition of ____________

The two types of data collection in SIGINT are ____________ and ____________

The collection of technical and intelligence information from foreign communications by other than the intended recipient is ____________

The gathering of information from foreign, non-communication types of EM radiation is ____________

____________ is the unit of frequency measurement

What does the Scan Control Table (SCT) establish?

The hierarchies are divided into what two major elements?

Of the ELF, PLF, and SLIK which can be updated during mission planning?

Of the ELF, PLF, and SLIK which can be updated while in the air?

Establishes how often this part of the spectrum will be searched within a single pass of the SCT

The time needed to get a single pulse. If not long enough it may cause the emitter to be missed

The rate of motion for EM energy

The axis of movement perpendicular to the direction of both the electrical and magnetic fields

The orientation of a wave's electrical field

The number of cycles or repetitions of a sine wave that occur per second

The time it takes for EM energy to complete one cycle

Point of the waveform through which the wave is passing

The distance between points having a corresponding phase in two consecutive cycles of a sine wave

Which parameter is changed to affect the pitch of a carrier wave

Which parameter is changed to affect the tone of a carrier wave

Allowing the insantaneous carrier amplitude to be controlled by the characteristics of the modulating signal is ____________

when the modulation signal is applied in the amplitude modulation process what are the new frequencies generated called?

What is the definition of Pulse Modulation

Descricbe FMOP (Frequency modulation on Pulse)

Describe PMOP (Phase modulation on Pulse)

What is the time that the radar set is transmitting RF energy?

What is the number of pulses per second that the radar transmits defined as?

Signal or echo that is received when a pulse is reflected from a target

The distance that a radar pulse travels in 12.4 micro seconds

What is the distance in degrees between the half power points of a beam

The method of pulse coding that increases range resolution while keeping a long range detection capability

The ability of a radar to separate two targets close in azimuth at approximately the same range

What parameters affect the range resolution of a radar

What parameters affect maximum and minimum theoretical range

What parameter affects azimuth resolution

What type of sector would you use to reduce AEF overloads?

The PDS average scan cycle time exceeds a defined threshold. Remove auto processing, no-scan, or change direct scan.

What is the function of the LRUD

How are early warning radars best described?

What kind of scan, pulse width and beam width do early warning radars normally use

What are the usual power and PRF characteristics of acquisition radars

what type of beam does a V-Beam radar at a GCI site have

GCI radars provide what type of information

TT Radars, in general, use what type of PW and Beam Width

What type of information is normally provided by TI radars

MG radars normally use what kind of scan

Using each echo pulse from the target to determine a new azimuth and elevation correction signal is the definition of ____________

Using two narrow pencil beams, each pointed slightly off antenna boresight, is ____________

Continuously rotating an offset antenna beam is ____________

If a lobe on receive only mode of operation is used with a conscan radar, the radar is called ____________

The mode of transmitting on one antenna that does not scan and receiving on another antenna that does scan is called ____________

If a lobe on receive only mode of operation is used with a track while scan radar, the radar is called ____________

A radar that uses calculations based on the frequency difference between the transmitted pulse and the received pulse is ____________

Using two separate beams and two separate antennas on two different frequencies with one scanning in elevation and the other scanning in the horizontal is the definition of ____________

Radar that Sweeps around a full circle with a steady elevation

Radar that sweeps back and forth across a sector

Radar that Sweeps through a sector in one direction

Scan type that is produced by rotating a feed horn around the center of a stationary disc

Scan type that is a thin beam used to cover a rectangular area by horizontally sweeping the area

A scan that has no motion but the antenna may move to follow a target

A scan that is a thin beam scanned conically to cover a larger circular area

The conical scan combined or superimposed on another type of scan

Capable of producing and switching between various types of scan patterns

Increasing revisits in Scan Requirements will have what effect on scan times

what things tend to have an effect on triangulation capability

What call is used to request ambiguity resolution from the SIA

What document dictates the EEP requirements before offboard reporting can occur

What are the three types of special tunes

What special tune is always automatic and cannot be turned off

What special tune provides the analysis is commonly used first to eliminate ambiguous emitters?

____________ has the largest impact on overall system scan times

Aircraft is gathering EOB on a designated emitter; generally followed by signal type, bearing, and range if able

What is the call made when a known identification to a specified system at the stated location

No emitters of interest detected

Tactical report used to provide perishable information of tactical significance for the immediate attention of tactical commanders