1What is the difference between a haboob, dust storm, and sandstorm?
Dust storm is wind-lofted fine dust over a wide area at 3,000-6,000 ft; sandstorm is heavier sand in lowest ~10 ft and localized; haboob is a dust/sandstorm from cold thunderstorm downdrafts that is short-lived and intense.
2What is fog?
Fog is a visible aggregate of minute water droplets, like a cloud that the base touches the Earth's surface
3What is advection fog and where does it typically occur?
Moist air over a colder surface cools below its dewpoint, occurring most commonly along coastal areas, moving deep into continental areas, and called sea fog at sea.
4What is radiation fog?
Fog produced when radiational cooling reduces air temp to at or below its dewpoint, generally occurs at nighttime.
5What is mountain or valley fog?
Fog formed when cold air drains into valleys.
6What is upslope fog?
Fog formed when moist, stable air cools while rising up terrain.
7What is frontal fog?
Formed when precipitation evaporates cold air into fog.
8What is steam fog?
Fog formed when very cold air moves over warm water.
9What is freezing fog?
Fog that occurs at or below 32 celsius.
10What is ice fog?
Fog made up of ice crystals.
11What causes turbulence?
Convective currents, obstructions to wind flow, and wind shear.
12What is the difference between mechanical and wind shear turbulence?
Mechanical turbulence occurs when wind hits obstructions like trees, buildings, or mountains to create eddies, whereas wind shear involves air currents with different speeds and/or directions.
13What is a temperature inversion and why is it important to pilots?
Temperature increases with altitude, and wind shear and turbulence often occur in the boundary between cold and warm air currents.
14What are the 3 ingredients to a thunderstorm?
Water vapor, unstable air, and a lifting mechanism.
15What are the 3 principal thunderstorm types?
Single-cell, multicell, and supercell.
16Where do vertical winds occur in a microburst?
In all microbursts, strengthening with altitude and peaking at ~500ft AGL, with strongest downdrafts peaking near the center exceeding speeds of 3000fpm.
17What are 2 factors that influence thunderstorm motion?
Advection (individual cells moving with the average wind through vertical depth of a cumulonimbus cloud) and propagation (old cell dissipation and new cell development).
18What are pilot actions if encountering a downdraft during an approach or takeoff?
On approach, be ready to go missed at the first sign; after takeoff, keep or increase pitch and accept lower airspeed.
19How does engine water ingestion occur in a thunderstorm?
Updrafts concentrate water, especially when their speed approaches or exceeds raindrop fall speed, and excess water can cause a flameout or engine damage.
20What are the thunderstorm avoidance guidance points for landing or taking off and flying under a thunderstorm or anvil?
Do not land or takeoff in the face of an approaching thunderstorm, do not attempt to fly under a thunderstorm, and do not attempt to fly under the anvil of a thunderstorm.
21How far should you avoid any thunderstorm?
By at least 20mi of any thunderstorm.
22What does vivid and frequent lightning indicate?
The possibility of a severe thunderstorm.
23What thunderstorm cloud height is regarded as extremely hazardous?
Any thunderstorms at or higher than 35,000ft.
24What should you do if unable to navigate around an area of thunderstorms?
Divert or wait out thunderstorms on the ground.
25How does radiation fog come to be?
Ground loses heat to the sky and cools the air above it to its dewpoint, favored by clear skies, light winds, and a shallow moist layer, usually at night lasting past sunrise.
26What type of fog is most prevalent on the west coast of the US and why?
Advection fog, because it forms offshore over cold water and the wind carries it inland.
27Why is smoke or ash bad for an aircraft?
It is hard to see or detect and radar may miss it, ash melts on turbine parts causing flameout, windshields get sandblasted and obscured, abrasion strips paint and pits metal, and it contaminates systems and causes runway traction loss.
28What are the causes and effects of mechanical turbulence?
Obstructions like trees, buildings, and mountains disrupt wind flow into eddies; unstable air forms larger eddies that break up quickly, stable air lets them die out slowly, and mountain waves are one form.
29What are the 3 causes of turbulence?
Convective (rising and sinking air from surface heating), mechanical (obstructions to airflow), and wind shear (air currents with different speeds or directions).
30What is wind shear?
A sudden, drastic change in wind speed and/or direction over a small area that affects any flight at any altitude.
31How does temperature inversion cause turbulence?
Strong wind shear often occurs across inversion layers, generating turbulence.
32What are the 3 types of structural icing?
Rime (rough, milky; small droplets freeze instantly; cold, low liquid water), clear (glossy, dense; large droplets freeze slowly; warmer, high liquid water; forms horns; hard to see), and mixed (clear and rime combined; hazard like clear ice; harder to remove than rime).
33What is HIWC and why is it dangerous to aircraft?
High Ice Water Content consists of high altitude ice crystals and can affect turbine engine performance, including causing flameouts.
34What is supercooled water, where does it form, and is it bad for aircraft?
Liquid water below $0^{\circ}C$, mostly in clouds from 0 to $-10^{\circ}C$; it is hazardous because it freezes on contact, and SLD are especially dangerous.
35Where do rime, clear, SLD, and mixed icing occur?
Rime in stratiform and upper cumuliform clouds colder than -15C; clear and SLD in cumuliform clouds and below fronts (clear warmer than -10C); mixed in stratiform and cumuliform clouds between rime and clear (-10 to -150).
36What are the 4 main icing factors?
Supercooled Liquid Water Content (SLWC), temperature/altitude, droplet size, and aircraft design and airspeed.
37How do updrafts and downdrafts work?
Updrafts are rising currents that can build cumulus or cumulonimbus, while downdrafts are columns of sinking air, usually with precipitation, where strong ones cause microbursts.
38What are the EF ratings and classes of tornadoes?
Weak EF-0 (65-85 mph) and EF-1 (86-110), strong EF-2 (111-135) and EF-3 (136-165), and violent EF-4 (166-200) and EF-5 (>200).
39What causes a microburst to be symmetrical vs. asymmetrical?
Outflow spreads outward symmetrically or asymmetrically, with asymmetry caused by ambient environmental winds, storm motion, and vertical wind shear.
40What are the stages of a thunderstorm?
Towering cumulus (strong updraft over 3,000 fpm), mature (precipitation reaches ground, downdraft spreads out as cool gusty air, hazards peak late), and dissipating (downdraft replaces updraft, precipitation tapers off, top of anvil remains).
41What are downbursts and microbursts?
A downburst is an intense downdraft with strong, damaging winds and wind shear, and a microburst is a smaller, shorter-lived downburst under 2.5 mi wide and ~1,000 ft deep lasting 5-15 min.
42What are the 3 stages to a downburst lifecycle?
Formation, impact, and dissipation.
43What is a tornado?
A violently rotating column of air in contact with the ground, often a visible funnel cloud, with wind speeds estimated from damage using the EF scale.
44How does static electricity affect radio receivers?
Aircraft flying through clouds, precipitation, or particles build up charge that discharges from sharp metal points, causing steady, high-level noise in radio receivers mostly at lower frequencies, common near thunderstorms.